Sierra Products EasyFire MODEL EF 3801 Instructions d'exploitation télécharger pdf

Sierra Products, Inc.

5061 Brooks St., Ste. B

Montclair, CA 91763

Listed by OMNI-Test Laboratories, Inc.

Report No. 256-S-01-4

Please read this entire manual before installation. Save these instructions.

EF3801B-AL Pellet Heater

Installation & Operating Instructions

WARNING: THIS HEATER SHOULD NOT BE

INSTALLED IN A SLEEPING ROOM.

PLEASE READ THIS ENTIRE MANUAL BEFORE

INSTALLATION AND USE OF THIS PELLET FUEL-

BURNING ROOM HEATER. FAILURE TO FOLLOW

THESE INSTRUCTIONS COULD RESULT IN

PROPERTY DAMAGE, BODILY INJURY OR EVEN

SAFETY NOTICE

< CAUTION: HOT WHILE IN OPERATION. KEEP

CHILDREN, CLOTHING AND FURNITURE AWAY.

CONTACT MAY CAUSE SKIN BURNS.

< IF THIS HEATER IS NOT PROPERLY INSTALLED,

A HOUSE FIRE MAY RESULT.

< FAILURE TO COMPLY WITH OWNERS' MANUAL

INSTRUCTIONS WILL VOID YOUR WARRANTY!

INSTALLER: PLEASE LEAVE THIS MANUAL WITH

THE OWNER!!

GENERAL INFORMATION

Installation and repair should be done by a qualified service

person. The heater should be inspected before use and at

least annually by a professional service person. More

frequent cleaning may be required due to fuel quality,

excessive lint from carpeting, bedding m aterial, etc. It is

imperative that control compartm ents, burners and circulat-

ing air passageways of the heater be kept clean.

The EASYFIRE Pellet heater has been designed and

approved for burning wood pellet fuel only. Burning other

forms of fuel is not permitted and will void all warranties.

This unit has been approved for use with a 3" Type L Pellet

Vent System .

NEVER use gasoline, gasoline-type lantern fuels, kerosene,

charcoal lighter fluid, or similar liquids to start or "freshen

up" a fire. Keep all such liquids well away from the heater

while it is in use.

Ashes must be disposed of in a metal container with a tight

fitting lid and placed on a noncombustible floor or ground,

well away from all fuels, pending final disposal.

NOTE : During the first few burns the high temperature

paint and sealant used in manufacture will emit some odor

and smoke. Open doors and windows to the outside for

proper ventilation during the first burn cycle and curing of

the paint.

This heater, when installed, must be electrically grounded in

accordance with local codes or, in the absence of local

codes, with the National Electrical Code, ANSI/NFPA 70-

2006.

Provide adequate clearances around air openings into the

combustion chamber and adequate accessibility clearance

for servicing and proper operation. Never obstruct the front

opening of the heater.

The heater may be installed as a free-standing unit mounted

on a non-com bustible protective floor pad or hearth. O r it

may be mounted into an existing U. L. approved wood stove

chimney. Non-combustible floor protection is required and

must be used when placing the heater on any combustible

material.

The pellet heater must be operated with a power source and

will not operate using natural draft. If there is a power failure

the heater will shut down. If the 12 volt back system is in-

stalled, the heater will automatically switch to 12 volt power.

The EasyFire Pellet Heater has been listed by OMNI-Test

Laboratories, Inc. to ASTM, U.L.,and EPA Standards.

1 2 3 4 5 6 ... 10 11

Résumé du contenu

Page 1 - EF3801B-AL Pellet Heater

Sierra Products, Inc.5061 Brooks St., Ste. BMontclair, CA 91763Listed by OMNI-Test Laboratories, Inc.Report No. 256-S-01-4Please read this entire manu

Page 2

Figure 19 Feed system access through hopper5. Problem: We had a power failure and the heateremitted smoke for about five minutes.Solution: If the he

Page 3

5061 Brooks St., Ste. B Montclair, CA 91763Phone 1-909-399-3355 Fax 1-909-399-3357www.sierraproductsinc.netP/N 140661r3 02/08ITEM No. PART NUMBER DESC

Page 4 - DOOR HANDLE ASSEMBLY

2Figure 1 -Overall DimensionsFigure 2OUTSIDE COMBUSTION AIR IS MANDATO RY INMOBILE OR MODULAR HOME INSTALLATIONS.CAUTIO N: DO NOT CONNECT TO ANY AIRD

Page 5 - Priming the feed system

3Figure 3Figure 4Figure 5Figure 6c. 2 ft. minimum to an adjacent building and 7 ft.minimum above grade when located adjacent topublic walkways.

Page 6 - MATCH LIGHT FIRE AND START-UP

4Figure 7 Rear Connection PanelFigure 8 Stove Connection PanelAutolite Wiring DiagramUNIT INSTALLATIONRoute the power supply cord so that it does not

Page 7 - CANADIAN REQUIREMENTS

5Figure 9 Door handle assemblyFigure 11 Hopper safety switch-close lid to operateWarning: This stove incorporates a hopper lid safetyswitch. The fee

Page 8 - MAINTENANCE PROCEDURE

6Figure 13Prior to stove operating on thermostat, confirm properoperation by servicing and adjusting the stove asoutlined in the “Installation Guide”.

Page 9 - TROUBLE-SHOOTING

7heat exchanger hot before turning it to "LO W ". You willneed to burn the heater for a few hours before decidingwhich setting is best for

Page 10

8Figure 15Figure 16Figure 174. Clearance to combustibles may only be reduced bymeans approved by the regulatory authority.5. Store pellet fuels in a d

Page 11 - P/N 140661r3 02/08

9Figure 18 Air box clean out, air damper adjustmentThe EASYFIRE will automatically switch to 12 volt backupprovided you have the 12 volt option instal

Commentaires sur ces manuels

Pas de commentaire

Sierra Products EasyFire MODEL EF 3801 Instructions d'exploitation

Naviguer en ligne ou télécharger Instructions d'exploitation pour Poêles Sierra Products EasyFire MODEL EF 3801. Sierra Products EasyFire MODEL EF 3801 Operating instructions Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels